How To Reset Oil Life On Honda Civic 2008

Coach Gr  » happy »  How To Reset Oil Life On Honda Civic 2008
0 Comments

How To Reset Oil Life On Honda Civic 2008. Hold the sel reset button for about 10 seconds, or until the screen reads “oil life 100%” instead of “service”. Honda model with driver information interface (dii) step#1:

How to reset oil life Honda Civic 2005, 2006, 2007, 2008, 2009, 2010 from www.themechanicdoctor.com

The engine oil indicator will then start to blink. Get a shop manual for your car: If you like to reset any maintenance oil light after an oil change.

Use (+) To Choose Vehicle Information, Then Hit The Source Button.

Or reset check engine light, airbag light,. Honda model with driver information interface (dii) step#1: Close all doors gear to the park position.

Press And Hold The Select Or Reset Button For Ten Seconds To Reset Honda’s Oil Life Indicator.

The engine oil life indicator and the maintenance code (s) will blink. To reset oil life on a honda civic 2008, you can do the following steps. Press and hold that button until a service indicator appears below the tachometer.

Once It Blinks, Hold It Again For 5 Seconds.

On the far left side of the dashboard, below the vent, is a select/reset button (“sel reset”). Press the select/reset button until the engine oil life indicator is displayed. Then, press the select/reset button until the engine oil life indicator pops up.

Hold The Sel Reset Button For About 10 Seconds, Or Until The Screen Reads “Oil Life 100%” Instead Of “Service”.

Press the sel/reset button repeatedly until the engine oil life indicator is displayed. After you are on the screen, press and hold the trip knob until the oil life begins to blink. Maintain the “sel” button for five seconds till the show.

2008 Honda Civic Maintenance Light Reset Instructions.

While the oil life is flashing, release the trip button and press and hold again until the oil life is reset to. (this is called accessory mode.) look on the instrument cluster for. Turn the ignition to run (one position before starting engine).


Leave a Reply

Your email address will not be published.